LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine System (Crankshaft & Cylinder Block - Service Information - CRUA)) >> 13 Crankshaft, Cylinder Block >> Pistons And Connecting Rod >> Oil Spray Jets, Removing And Installing >> Installing

Oil Spray Jets, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal And Note The Following: 

CAUTION:

Risk Of Damaging The Oil Spray Jets.

  • Do not bend the oil spray jets.
  • Check the oil spray jet clearance after reinstalling the pins.
  • Bent oil spray jets must be replaced.

-- Align the guiding edge of the oil spray jet to the machined surface of the cylinder block.

-- Install the oil pan. Refer to OIL PAN, REMOVING AND INSTALLING .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

scientia non olet · About LEMON Manuals