Overview - Cylinder Block, Transmission Side: Notes
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 60 Nm + 90°
- Always replace after removing.
- Flywheel
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Only possible to install in one position
- Sensor Wheel
- For the Engine Speed Sensor -G28-
- Removing and installing. Refer toSEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Engine Speed Sensor -G28-
- Overview. Refer to OVERVIEW - GLOW PLUG SYSTEM .
- Bolt
- Tightening specification. Refer to OVERVIEW - GLOW PLUG SYSTEM .
- Alignment Pin
- Quantity: 2
- Intermediate Plate
- Be careful not to damage or bend it when installing.
- Installing. Refer to Intermediate Plate, Installing .
- Transmission Side Sealing Flange
- Replace after removing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- With shaft seal
- Bolt
- Tightening specification and sequence. Refer to Transmission Side Sealing Flange - Tightening Specifications and Sequence .