LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine System (Crankshaft & Cylinder Block - Service Information - CRUA)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Removing

Ribbed Belt, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Before removing the ribbed belt, mark the running direction with chalk or a felt-tip pen for reinstallation.

GWWA13-10949

-- Pivot the tensioner counter-clockwise in direction of -arrow- using a wrench to release the tension on the ribbed belt.

-- Secure the tensioner using the :T10060A  .

-- Remove the ribbed belt.

scientia non olet · About LEMON Manuals