LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine System (Crankshaft & Cylinder Block - Service Information - CRUA)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Engine Support, Removing And Installing >> Installing >> Notes

Engine Support, Removing And Installing: Installing: Notes

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal And Note The Following: 

-- Install the bolt -2- before installing the engine support in the engine support hole.

-- Position the engine support and tighten the bolts -1, 2 and 3- hand-tight.

GWWA10-11625

-- Then tighten to the specified tightening specification and sequence. Refer to figure below.

-- Install the upper toothed belt guard. Refer to TOOTHED BELT GUARD, REMOVING AND INSTALLING .

-- Install the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals