LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine System (Crankshaft & Cylinder Block - Service Information - CRUA)) >> 13 Crankshaft, Cylinder Block >> Crankshaft >> Crankshaft Needle Bearing, Replacing >> Installing

Crankshaft Needle Bearing, Replacing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
GWWM13-10009

-- Clean the bearing seat in the crankshaft and apply a thin coat of grease.

-- Drive the needle bearing into the crankshaft up to the installation depth using the :VW207C  .

Installation Depth Dimension a = 2.0 mm

GWWM13-10031
NOTE:

If the needle bearing is unintentionally pushed in to deeply, it must be replaced, because it will be damaged when it is removed again.

scientia non olet · About LEMON Manuals