Oil, Filling
-- Replace oil filler plug after removing.
- The vehicle must be level.
-- Place the :SMN372500 under the front axle differential lock.
-- Use A Commercially Available Hose Approximately (1.50 M Long) With Outer Circumference Approximately 15 Mm And A Commercially Available Funnel To Fill:
-- Route the Hose -A- through the engine compartment.
-- Clean the area near the front axle differential lock oil filler plug -arrow-.
-- Cover neighboring components.
-- Remove the oil filler plug -arrow-.
-- Insert Hose -A- in the filler hole -arrow-.
- The hose must not sag.
-- Insert funnel in Hose -A-.
-- Fill with oil until some starts to escape from between the hose and the oil fill hole.
-- Remove Hose. Some extra oil may drain out.
- The oil level is correct when it fills up to the lower edge of the oil fill hole.
-- Install a new oil filler plug -arrow- and tighten it to the tightening specification.
-- If necessary, clean the area near the front axle differential lock oil filler plug -arrow- and neighboring components.