All Wheel Drive Clutch Pump -V181-, Removing And Installing: Installing: Notes

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install In Reverse Order Of Removal While Noting The Following:

-- Replace the O-rings -1 and 2- if damaged and coat with a thin layer of front axle differential lock fluid.

-- Push in the All Wheel Drive Clutch Pump -V181- -2- all the way. Note the routing of the wiring harness when doing this.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts -1- to the tightening specification.

-- Connect the connector -arrow- for the All Wheel Drive Clutch Pump -V181- to the Differential Locks Control Module -J647-.

-- Check the front axle differential lock fluid and fill if necessary. Refer to FRONT AXLE DIFFERENTIAL LOCK FLUID .

-- Check function. Refer to FUNCTION, CHECKING .