Removing the Spring Pin for the Differential Bevel Gear Axle
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
|
-- Use a 5 mm diameter drift -B- to remove the adapter sleeve -A- from the hole -arrow- on the differential housing.
NOTE:
If there is no hole -arrow- on the differential housing, remove the adapter sleeve as follows:
 Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
|
Cover the inner race/tapered roller bearing in order to prevent possible damage and entry of shavings.
Remove the spring pin using a chisel.