LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Final Drive & Differential Systems (Service Information - 6-Speed Manual Transmission - 02Q)) >> 39 Final Drive, Differential >> Differential >> Differential, Disassembling And Assembling >> Differential, Disassembling And Assembling, AWD, Fwd With Front Axle Differential Lock >> Removing The Differential Bevel Gear Axle And Spring Pin

Removing The Differential Bevel Gear Axle And Spring Pin

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
GWWA39-10600Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use a 5 mm diameter pin punch -B- to remove the adapter sleeve -A- from the hole -arrow- on the differential housing.

NOTE:

If there is no hole -arrow- in the differential housing, remove the adapter sleeve as follows:

GWWA39-10003Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install the adapter sleeve -1- in the differential bevel gear axle -2- so that it is flush.

Place the differential under the press with the adapter sleeve -arrow- facing the :30-23  .

Then, remove the differential bevel gear axle.

If necessary, remove the sheared parts of the adapter sleeve from the differential bevel box housing and remove the differential bevel gear axle.

scientia non olet · About LEMON Manuals