Removing the Lower Front Bonded Rubber Bushing
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
-- To prevent oil from leaking out of the final drive in the following step, seal off both vent pipes.
-- Place the final drive on the work bench with the upper section facing down and remove the bonded rubber bushing.
A -:VAS251621 (Kukko 22-1)
B -:VAS251601 (Kukko 21-1)
-- A piece must be broken out of the bonded rubber bushing collar -arrow- to attach the Support.
-- Insert the Internal Puller in the joint of the upper and lower bonded rubber bushing and tension.