Overview - Final Drive
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 60 Nm +180°
- Replace after removing.
- Stop Washer
- Washer
- Installation position: the bevel (smaller diameter) faces the subframe
- Screws
- 60 Nm +180°
- Replace after removing.
- Rear Subframe
- Stop Washers
- Rear Final Drive
- Removing and installing. Refer to FINAL DRIVE, REMOVING AND INSTALLING .
- Bonded Rubber Bushing, Removing and installing. Refer to BONDED RUBBER BUSHING, REMOVING AND INSTALLING .