Driveshaft, Removing And Installing: Notes
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Counterhold - Multiple Use:T10172A
- Engine and Gearbox Jack:VAS6931
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Pendulum support
- Bolts - Driveshaft
NOTE:
Working on the driveshaft should only be performed with the vehicle on a two-column workshop hoist.
Mark the position of all the parts before removing them. Install the parts in the same position, otherwise the imbalance can damage the bearing causing a humming noise.
Do not bend the driveshaft, only store and move when fully extended.
Do not allow the driveshaft to >>hang down<< during removal. Always support it.
Always remove or install the driveshaft horizontally with respect to the drive flange.