Driveshaft, Removing And Installing: Installing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Install all parts marked to each other in their original positions.

Installing the Intermediate Bearing Free of Tension

-- Align the intermediate bearing in its elongated holes so the driveshaft or bearing is not under stress.

-- Tighten the intermediate bearing only after the driveshaft has been attached.

-- Tighten the driveshaft and intermediate bearing.

-- Remove the heat shield -1- on the bevel box. Refer to Bevel Box .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the pendulum support with >>new<< bolts. Refer to SUBFRAME MOUNT [For engine(s) CNSB, CNSA, CXBB, CXBA, CXCB, CXCA] .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the center tunnel heat shield under the intermediate bearing. Refer to appropriate service information. .

-- Install the exhaust system. Refer to EXHAUST PIPES/MUFFLERS [For engine(s) CRUA] or EXHAUST PIPES/MUFFLERS [For engine(s) CNSB, CNSA, CXBB, CXBA, CXCB, CXCA] .

-- Install the rear tunnel brace. Refer to UNDERBODY TRIM PANEL .

-- Install the noise insulation. Refer to NOISE INSULATION .