All Wheel Drive Clutch, Removing And Installing: Installing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Remove the old O-ring -arrow- from the all wheel drive clutch.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the new O-ring -arrow- and lightly lubricate with High Performance All Wheel Drive Clutch Oil.

-- Insert the all wheel drive clutch -1- in the rear final drive. Install :T10093 for exact guidance.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Rotate at the driveshaft flange -2- and insert all wheel drive clutch all the way in.

-- Tighten the bolts -arrows- to the tightening specification.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the connector -B- from the All Wheel Drive Control Module -J492- -A-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The connector -C- must also be connected.

-- Attach the driveshaft to the rear final drive. Refer to DRIVESHAFT, REMOVING AND INSTALLING .

-- If removed, install the center tunnel heat shield under the intermediate bearing. Refer to .

-- Install the exhaust system and align it without tension. Refer to EXHAUST PIPES/MUFFLERS [For engine(s) CRUA] or EXHAUST PIPES/MUFFLERS [For engine(s) CNSB, CNSA, CXBB, CXBA, CXCB, CXCA] .

-- Add High Performance All Wheel Drive Clutch Oil and check the oil level in the all wheel drive clutch. Refer to ALL WHEEL DRIVE CLUTCH OIL, DRAINING AND FILLING .