All Wheel Drive Clutch Pump, Removing And Installing: Removing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch off the ignition.

-- Place the :SMN372500 under rear the final drive.

-- Remove the drain plug -A- and completely drain the High Performance Oil for All Wheel Drive Clutch.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install drain plug -A- with new sealing ring and tighten.

-- Remove the connector -arrow- for the All Wheel Drive Clutch Pump -V181- from the All Wheel Drive Control Module -J492-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip and free up the wiring harness -3- for the All Wheel Drive Clutch Pump -V181- from the housing.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Ignore the bolt -arrow-.

-- Place the :SMN372500 under rear the final drive.

-- Remove the bolt -1- from the All Wheel Drive Clutch Pump -V181-.

-- Remove the All Wheel Drive Clutch Pump -V181- -2- from the all wheel drive clutch housing.