All Wheel Drive Clutch Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install in reverse order of removal and note the following:

-- If the removed All Wheel Drive Clutch Pump -V181- is being installed again, replace the O-rings -1 and 2-.

-- Lightly coat the O-rings -1 and 2- with High Performance Oil for All Wheel Drive Clutch.

-- Press the All Wheel Drive Clutch Pump -V181- -2- all the way into the all wheel drive clutch housing. Make sure the wiring harness -3- is routed correctly.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Ignore the bolt -arrow-.

-- Tighten the bolts -1-.

-- Attach the connector -arrow- for the All Wheel Drive Clutch Pump -V181- on the All Wheel Drive Control Module -J492-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Add High Performance All Wheel Drive Clutch Oil and check the oil level in the all wheel drive clutch. Refer to ALL WHEEL DRIVE CLUTCH OIL, DRAINING AND FILLING .