Right Seal, Replacing, Fwd: Installing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Lightly oil the new gasket on the outer edge.

-- Fill the area between the sealing/dust lip -arrow- halfway with Sealing Grease.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the seal all the way in without tilting it.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Press the flange shaft against the transmission so that the bolt in the threaded piece of the differential touches.

-- Insert the flange shaft and secure it with bolts.

-- Install the ball joint. Refer to LOWER CONTROL ARM AND BALL JOINT .

-- Fasten the drive axle to the flange shaft. Refer to DRIVE AXLE .

-- Install the heat shield over the right drive axle, if equipped. Refer to DRIVE AXLE .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the fluid level and fill if necessary. Refer to TRANSMISSION FLUID LEVEL, CHECKING .

-- Install the noise insulation. Refer to NOISE INSULATION .