Right Flange Shaft, Removing And Installing: Installing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace flange shaft countersunk screw.

-- Remove the sealing ring -A- from the groove -arrow- and replace it.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Carefully install the flange shaft while rotating it at the same time.

-- Fasten the flange shaft with a new bolt -item 1- OVERVIEW - BEVEL BOX .

-- Install the right drive axle. Refer to DRIVE AXLE .

-- Install the heat shield above the right drive axle arrows, if equipped. Refer to DRIVE AXLE .

-- Add gear oil to the bevel box. Refer to GEAR OIL LEVEL, CHECKING AND FILLING .