Output Flange, Replacing And Selecting New Shim For Output Flange, Bevel Box Removed: Notes
Special tools and workshop equipment required
- Holding Fixture:VW313
- Press Piece - 42mm:VW516
- Press Piece - Multiple Use:40-105
- Seal Installer - Flange Shaft:T10049
- Gearbox Support:T10108
- Gearbox Support:T10108/1
- Puller - Taper Roller Bearing:VAG1582 with a short sleeve
- Puller - Taper Roller Bearing - Adapter 6A:VAG1582/6A
- Puller - Taper Roller Bearing - Adapter 13:VAG1582/13
- Torque Wrench 1601:VAG1601
- Three-Arm Puller:VAS251205 (45-2)
- -1- Three-Arm Puller:VAS251001 (20-10)
- Press Piece - Multiple Use:VW412
- Press Piece - Multiple Use:VW454
- Press Piece - Multiple Use:VW455
- Press Plate:VW401
- Two M8 x 30 mm stud bolts or Guide Pins - M8:T10273
- Removal Device Pin 2:VW460/2
- Sealing Grease.
- Sliding Gauge
- Two M 10 x 30 bolts
- Four M 12 x 10 nuts
It is possible to remove the bevel box output flange only when the bevel box is removed.
The tapered roller bearing for the bevel box output flange is not replaced.
Select the new shim for the output flange only when the bevel box is removed.
-- Remove the bevel box. Refer to BEVEL BOX, REMOVING .
-- Mount the bevel gear on the hole marked with the number -4- -arrow- in the :T10108 .
A Insert the M 12 x 10 nut (quantity: 4) between bevel box and Transmission Holder.-
-- Then align bevel box to the remaining three holes and secure.
-- Place a drip tray underneath.
-- Drain the transmission fluid from the bevel box.
-- Secure the bevel box output flange using the :T10108/1 . Use M10 x 30 bolts -arrows- to lock the flange.
-- Remove the hex nut for the output flange.
A -36 mm Socket for 3/4 Inch Drive
-- Pivot the bevel box so that the output flange faces upward.
-- Remove the output flange and bearing inner race/tapered roller bearing from the bevel box shaft bevel gear.
A -:VAS251013 (Kukko 45-2)