Reducing Agent Injector -N474-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install In Reverse Order Of Removal And Note The Following:

NOTE:

Replace the seal.

Secure all hose connections with hose clamps that match the ones used in series production.

Installation position: the tabs in the Reducing Agent Injector -N474- -2- must fit into the mounts in the exhaust pipe -1- -arrows-.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Adapt the adaptation value for the SCR system after draining reducing agent or replacing components. Refer to SELECTIVE CATALYTIC REDUCTION (SCR) SYSTEM ADAPTATION VALUE, ADAPTING .