Reducing Agent Delivery Line Front Section, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the pulling aid from the old lines.

-- Clip the reducing agent delivery line in the clamp -2- for the lines.

-- Pay attention that the plug is seated correctly on the new lines.

-- Seal the lines with suitable plugs from the :VAS6122 .

NOTE:

The reducing agent delivery line, fuel line, bleed pipe, and fuel line for the parking/auxiliary heater are installed together.

Secure the lines for example with adhesive tape.

-- Insert the lines as shown in the shield guide and clip in. Refer to Installing .

-- The fuel lines are clipped in at the top of the shield only after guiding them in. Refer to Installing .

-- Secure the pulling aid on the fuel lines.

-- Use adhesive tape to secure the pulling aid.

-- Pay attention that the pulling aid is only secured in the front area of the lines.

-- Seal the shield at the bottom from the slotted guide with adhesive tape so that the lines do not slide out.

-- Place the fuel lines together with the shield on the opening in the longitudinal member.