LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Exhaust & Emissions Controls System (Service Information - CRUA)) >> 26 Exhaust System, Emission Controls >> Exhaust Pipes/Mufflers >> Front Exhaust Pipe, Removing And Installing >> Installing

Front Exhaust Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal And Note The Following: 

-- Replace the seal and screw-type clamp after removal.

-- Pay attention to the installation position of the screw-type clamp for the front exhaust pipe. The clamp must not touch other components.

-- Pay attention to the installation position of the seal between the emissions control module and front exhaust pipe. Refer to Installation Position of the Seal between the Emissions Control Module and Front Exhaust Pipe. .

-- Install the exhaust system without tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .

scientia non olet · About LEMON Manuals