Exhaust Door Control Unit -J883-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
-- Attach the new Exhaust Door Control Unit -J883-. While doing so, make sure that the control unit coupling plate -1- engages in the exhaust door tab -2-.
-- Insert the new bolts and position the new nuts.
-- First tighten the upper bolt and then the lower one. Tightening specification: 10 Nm.
-- Remove the protective cap for the connector and connect the connector -1-. If necessary, attach the heat shield boot.
-- After replacing the Exhaust Door Control Unit -J883-, the adaptation values must be adapted in the engine control module. To do so, turn on the ignition and select the following menu items on the Vehicle Diagnostic Tester:
- 01 - Engine Electronics
- Guided Functions
- Basic setting
- Exhaust Door Adaptation