Clamping Sleeve Installation Position: Notes
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Clamping Sleeve Installation Position
-- Install the clamping sleeve in the position shown.
- The threaded connection points to the right in the direction of travel.
- The threaded connection -arrows- must not project over the lower edge of the clamping sleeve.
- Pay attention to the installation position of the screw-type clamp. The clamp must not touch other components.
Installation Dimension For Vehicles With Marking On The Exhaust Pipe
1 -Clamping Sleeve
2 -Exhaust Pipe
a -Installed Dimension
A -Exhaust System Marking
Installed Dimension -a- For The Clamping Sleeve:
a -8.5 mm