EGR Temperature Sensor -G98-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

During installation, all cable ties must be installed at the same location.

When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the connection on the turbocharger. Refer to TURBOCHARGER CONNECTIONS, REMOVING AND INSTALLING .

-- Remove the connector -1- from the bracket and release and remove it.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Free up the wire -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the EGR Temperature Sensor -G98- -1-.