LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Exhaust & Emissions Controls System (Service Information - CRUA)) >> 26 Exhaust System, Emission Controls >> Emissions Control System >> Emissions Control Module, Removing And Installing >> Installing >> Tightening Sequence Continuation

Tightening Sequence Continuation

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Emission Control Module Tightening Sequence
GWWN26-10904Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Step Bolt Steps
VIII Bolt -5- Install and pull to engage.
IX Bolt -5- Tighten to 20 Nm
X Bolt -5- additional 90° turn.
XI Bolt -5- An additional 45° turn

The rest of the assembly is performed in reverse order of removal, noting the following:

-- After replacing the emissions control module, perform the Adaptation  in Guided Functions  . Refer to Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals