Emissions Control Module, Removing And Installing: Installing: Notes

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Place the :T10511 on the engine.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Pay attention that the :T10511 retaining bracket is pivoted in the bulkhead direction - >>open<<.

Replace the seals, self -locking nuts, and clamps for the emissions control module after removing.

During installation, all cable ties for the heat shields must be installed at the same location.

CAUTION:

There is a risk of stress fractures and engine damage due to the emissions control module being installed under stress.

Before installing make sure that this lifter is not difficult to move or fixed.
The lifter must be easy to turn on the threads.
Lubricant can only be applied on the threads. The retainers must remain >>clean<<.
The bolt retaining tabs must be bent together so far that the lifter is taken with when the bolt is turned.