Exhaust & Emissions Controls System (Service Information - CRUA)

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

-- Check The Lifters -arrow- For Ease Of Movement.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the lifter completely clockwise (left threads).

-- Clean difficult to move threads and if necessary coat with rust remover.

CAUTION:

Lifter connections cannot be coated with every type of lubricant. Reducing the friction will impair the function of the lifter.

-- Bring the connections as follows with the :T10512 to the functional dimension.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the lifter on the striker pin and place in the centering sleeve.

-- Bend back the retaining tabs by lightly hitting the ball head with the heel of the hand.

-- Install the lifters all the way by hand and loosen again by approximately 45°.

-- Install the seal -1- on the emissions control module.

-- Remove the clamp bolt.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the clamp -2- completely on the emissions control module entrance funnel.

-- Do not bend the clamp.

-- Guide the emissions control module from below in the installed position, push upward and engage the bracket in the emissions control module mounting strap.

The emissions control module now hangs balanced in the approximate installation position.

NOTE:

Replace all emissions control module bolts after removal.