Diagnostic Mode 0A - Check Permanent DTC Memory : Procedure
- Erasing Permanent Fault Codes after code clear Service $0A - Permanent Fault Codes: can only be erased at the end of a driving cycle (during ECM keep alive time) if all the following conditions are fulfilled:
- ERASE: Permanent Fault Codes after code clear, the vehicle needs to be driven !
- NO FAIL: DTC cleared
- MONITORS: PASS
- MINIMUM: Conditions fulfilled 600 s. (cumulative) Engine running
- DRIVE: 300 s (cumulative) vehicle speed > 25 mph (40 km/h)