Diagnostic Mode 02 - Read Operating Conditions: Procedure
-- Connect the scan tool.
-- Start the engine and run at idle.
NOTE:
If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch ignition off afterward.
-- Select "Diagnostic Mode 2: Obtain operating conditions ".
-- From the following table, select the desired the "PID", e.g. "PID $05 Coolant temperature" that is to be monitored.
The current values of the component or system that is being monitored will be displayed on the scan tool screen.
| PID | Component or System |
|---|---|
| $00: | Supported PIDs $01-$1F |
| $02: | DTC Which Triggered Freeze Frame Data |
| $03: | Fuel system status |
| $04: | Calculated load value |
| $05: | Coolant temperature |
| $06: | O2 Sensor Bank 1 |
| $07: | O2 Sensor Adaptation Value Bank 1 |
| $0B: | Manifold Pressure |
| $0C: | Engine Speed |
| $0D: | Vehicle speed |
| $0E: | Firing angle cylinder 1 |
| $0F: | Intake Air Temperature |
| $11: | Absolute Throttle Position 1 |
| $12: | Secondary air status |
| $1F: | Time since engine start |
| $20: | Supported PIDs $21-$3F |
| $23: | Fuel Pressure (Rail Pressure) |
| $2E: | Fuel Tank Vent Valve Control |
| $2F: | Fuel Tank Level |
| $33: | Ambient Air Pressure |
| $40: | Supported PIDs $41-$5F |
| $42: | Engine Control Module system voltage |
| $43: | Absolute Load |
| $44: | Lambda specified value |
| $45: | Relative Throttle Position |
| $46: | Ambient temperature |
| $47: | Absolute Throttle Position 2 |
| $49: | Accelerator Pedal Position 1 Absolute |
| $4A: | Accelerator Pedal Position 2 Absolute |
| $4C: | Throttle Position Set Point |
| $51: | Fuel Type |
| $56: | Offset Lambda Control Behind Catalyst, Bank 1 |
| $60: | Supported PIDs $61-$80 |
| $70: | Boost Pressure Control |
-- Switch Ignition OFF