Intake Manifold Sensor -GX9-, CHECKING: Notes

From January 2014:Intake Manifold Sensor -GX9-, CHECKING 

From December 2015: Intake Manifold Sensor -GX9-, CHECKING 

General Description 

Air mass and charge pressure are two factors used for engine load management. For this purpose, there are several sensors with absolutely identical functions. They measure the intake air temperature and the intake manifold pressure. The first sender unit is located upstream of the Throttle Valve Control Module -J338- in the Intake Manifold Sensor -GX9-. They measure the pressure and temperature of the air in each individual cylinder bank. The values measured here correspond to the actual air mass in the cylinder bank(s).

Note the Intake Air Temperature Sensor -G42- / Manifold Absolute Pressure Sensor -G71- are also known as the Intake Manifold Sensor -GX9-.

The Intake Manifold Sensor -GX9- contains the following components: 

• Manifold Absolute Pressure Sensor -G71-.
• Intake air temperature sensor -G42-.

The Intake Manifold Sensor -GX9- components cannot be serviced separately, it must be serviced as a unit.

Special Tools And Workshop Equipment Required 

• Multimeter.
• Wiring Diagram.
• Scan Tool.

Test Requirements 

• Fuses OK.
• Battery voltage OK.
• Switch OFF all electrical and electronic accessories.
• Vehicles with Auto. Transmission, ensure Selector Lever position is in "P".
• Vehicles with Man. Transmission, ensure Shifter Lever position is in "N" with Parking Brake applied.
• Observe all safety precautions: SAFETY PRECAUTIONS .
• View clean working conditions: CLEAN WORKING CONDITIONS .