EVAP Canister Purge Regulator Valve 1 - N80-, CHECKING: Notes

General Description 

EVAP system is designed so that the admission of fuel vapors takes place only at idle and at light part-throttle. The EVAP Canister Purge Regulator Valve 1 -N80- is activated by the Engine Control Module -J623- to accomplish this task.

Special Tools And Workshop Equipment Required 

• Multimeter.
• Wiring Diagram.
• Scan Tool.

Test Requirements 

• Fuses OK.
• Battery voltage OK.
• Switch OFF All electrical and electronic accessories.
• Vehicles with Auto. Transmission, ensure Selector Lever position is in "P".
• Vehicles with Manual Transmission, ensure Shifter Lever position is in "N" with Parking Brake applied.
• Observe all safety precautions: SAFETY PRECAUTIONS .
• View clean working conditions: CLEAN WORKING CONDITIONS .