Heater Support Pump -V488-, REMOVING AND INSTALLING: Removing

NOTE:

During installation, all heat shield boots must be installed at the same location.

CAUTION:

The cooling system is under pressure when the engine is warm. Risk of scalding due to hot steam and hot coolant.

Scalding the skin and other parts of the body is possible.

Reduce the pressure by covering the coolant expansion tank cap with a cloth and carefully opening it.

-- Remove the coolant expansion tank cap -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the noise insulation. Refer to NOISE INSULATION .

-- Free up the wiring harness -1 and 2- from the air guide pipe.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the screw-type clamp -3-.

-- Remove the bolts -arrows-.

-- Loosen the hose clamp -arrow- and remove the charge air hose -1- with the air guide pipe downward.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

AWD Vehicles

Continuation for All Vehicles

-- Open the heat protection sleeve -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1-.

-- Disconnect the coolant hoses from the Heater Support Pump -V488- with :3094 .

NOTE:

Place a cleaning cloth underneath, to catch coolant leaking out.

-- Loosen the hose clamps -arrows- and remove the coolant hoses.

-- Remove the bolt -2- and the Heater Support Pump -V488-.