Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING: Installing

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and O-rings.

-- Coat the new O-rings -4- with coolant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Make sure both centering pins are installed in the cylinder block.

-- Install the connection piece -2- into the engine oil cooler -1-.

-- Push the Engine Temperature Control Actuator -N493- -3- into the connection piece and onto the centering pins in the cylinder block.

-- Tighten the bolts for the Engine Temperature Control Actuator -N493-. Refer to Engine Temperature Control ActuatorN493 - Tightening Specifications and Sequence .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .