LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf R Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> COOLING SYSTEM [4-Cylinder Direct Injection (2.0L, 4V, Turbocharger, Chain Drive, Generation III)] >> 19 Cooling System >> Radiator/Radiator Fan >> Radiator, Removing And Installing >> Installing

Radiator, Removing And Installing: Installing

Install In Reverse Order Of Removal And Note The Following: 

NOTE:

If there are small impressions on the fins, pay attention to the repair information. Refer to RADIATOR AND CONDENSER ASSEMBLY .

Replace the O-rings.

All of the coolant must be changed if the radiator was replaced.

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

-- Connect the coolant hose to the connector coupling. Refer to Figure.

-- Install the radiator grille. Refer to RADIATOR GRILLE, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to CHECK THE COOLANT LEVEL. .

scientia non olet · About LEMON Manuals