Engine Temperature Control Actuator -N493-, Removing And Installing: Installing

Install In Reverse Order Of Removal And Note The Following:

NOTE:

Replace the seals and O-rings.

-- Coat the new O-rings -4- with coolant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Make sure that both centering pins are installed in the cylinder block if necessary insert.

-- Install the connection piece -2- into the engine oil cooler -1-.

-- Push the Engine Temperature Control Actuator -N493- -3- into the connection piece and onto the centering pins in the cylinder block.

-- Tighten the bolts for the Engine Temperature Control Actuator -N493-. Refer to Figure.

-- Install the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to Filling .