Engine Coolant Temperature Sensor -G62-, Removing And Installing: Removing

-- Quickly open the coolant reservoir cap -arrow- and release any remaining pressure in the cooling system and then close it again.

Fig 1: Identifying Coolant Reservoir Cap

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Loosen the hose clamp -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove bolt -1-, push the left air guide pipe left.

-- Disconnect the connector -1-.

Fig 2: Identifying Engine Coolant Temperature Sensor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Place a cleaning cloth underneath, to catch coolant leaking out.

To prevent coolant loss, immediately insert the new Engine Coolant Temperature Sensor -G62- in the connection.

-- Remove the bolts -2-, and remove the Engine Coolant Temperature Sensor -G62- -3-.