LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf R Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> COOLING SYSTEM [4-Cylinder Direct Injection (2.0L, 4V, Turbocharger, Chain Drive, Generation III)] >> 19 Cooling System >> Coolant Pipes >> Coolant Pipe On Fan Shroud, Removing And Installing >> Removing

Coolant Pipe On Fan Shroud, Removing And Installing: Removing

-- Remove the bolts -1-.

GWWN24-10928Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the catch in direction of -arrow- and remove the cover -2-.

-- Free up the coolant hose -2-.

GWWN24-10929Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the retainers in direction of -arrows- and remove the air guide upper section -1-.

-- Remove the bolts -arrows-.

GWWN24-10931Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip and remove the lower section -1- of the air duct.

-- Seal off the coolant hoses with :3094  .

NOTE:

Place a cleaning cloth underneath, to catch coolant leaking out.

-- Loosen the clamps -3- and remove the coolant hoses.

-- Remove the bolts -2- and remove the coolant pipe -1-.

GWWN19-10913Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.