Low pressure side
- Refrigerant Circuits Adapter Set 1 - Adapter 12 :VAS6338/12
connected to the A/C Service Station and the Refrigerant Circuit Adapter Set - Adapter :VAS6338/48
.
High pressure side
- Refrigerant Circuits Adapter Set 1 - Adapter 3 :VAS6338/3
|
- Expansion Valve :VAS6338/44
or
|
Receiver/Dryer-- No adapter required, dryer is removed from receiver/dryer on condenser and the opening is sealed.-- Install a new reservoir (dryer) after the flushing procedure. Shut-off valve-- Shut-off valve (Heater and A/C Unit Refrigerant Shut-Off Valve -N541-) is removed and a Shut-Off Valve :VAS6338/42
is installed in its place. Replace the Heater and A/C Unit Refrigerant Shut-Off Valve -N541- after flushing. |
-- Using the Vehicle Diagnostic Tester start the "Refrigerant circuit, charging" function in the "Basic setting".
- Doing so opens the electric valves on the refrigerant circuit.
- The function is active and can only be ended when the refrigerant circuit has been flushed.
- Keep the Vehicle Diagnostic Tester connected so that the valves stay open.
|