Transmission Fluid Temperature Sensor 2 -G754-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Audi S4, 2015 Audi S4, 2014 Audi S4, 2013 Audi S4, and 2012 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

Transmission Installed:

-- Remove the rear noise insulation -2-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

CAUTION:

Danger of Causing Damage to the Transmission.

Without any or with too little manual transmission fluid inside the transmission:

do not start the engine and
do not tow the vehicle

Transmission Removed:

The transmission is secured to the engine/transmission holder. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .-

Transmission, Removed or Installed:

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

-- Disconnect the connector -2- from Transmission Fluid Temperature Sensor 2 -G754-.

Fig 2: Identifying Transmission Fluid Temperature Sensor

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Protect the connector -2- and the contacts on Transmission Fluid Temperature Sensor 2 -G754- from transmission fluid. Clean the connectors immediately if they come in contact with transmission fluid (Manual Transmission Fluid). Transmission fluid can cause contact problems in the connector contacts.

-- Remove the Transmission Fluid Temperature Sensor 2 -G754- -1-.

-- Drain the transmission fluid (MTF).

Install in reverse order of removal. Note the following: