Rear Axle Camber, Adjusting: Notes

Special tools and workshop equipment required 

• Insert Tool - 18 mm T10179
• Torque Wrench 1332 40-200 Nm VAG 1332

-- Loosen nut -A- of threaded connection of upper transverse link at subframe.

Fig 1: Identifying Upper Transverse Link Threaded Fastener Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Adjust camber by turning hex of eccentric bolt -arrow-.

-- Tighten nut -A-.

-- To do so, use Insert Tool - 18 mm T10179.

Fig 2: Identifying Nut And T10179

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

When using Insert Tool - 18 mm T10179, Tighten Nut to 80 Nm.

-- After tightening the nut -A-, (Fig. N44-10035), check the camber value once again.