Input Flange Seal: Installing

-- Before installation, lightly coat the new seal with high performance gear oil for Haldex coupling 052 175 A2 on the outside circumference and between the sealing lips.

-- Install the new seal using the Seal Installer - Shaft Seal Ring T10019. Do not tilt the seal.

Fig 1: Driving In New Seal To Stop Using Thrust Piece T10019

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the input flange using the sleeve 30-20.

-- Install the new nut using liquid locking fluid D 000 600 and tighten it to specification. Refer to Tightening Specifications .

Fig 2: Identifying New Hex Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A - M10 x 20 bolts

B - M8 x 15 bolt (installed in the Driveshaft Handle3145 from the rear)

-- Install the driveshaft. Refer to one of the following:

Passat, refer to

Tiguan, refer to DRIVESHAFT

CC and Golf R, refer to

-- Install the exhaust system and align it so that it is free of tension. Refer to Description And Operation .

-- Check the oil level in the Haldex clutch. Refer to .