Vehicle Diagnostic Tester, Connecting And Function Selecting
Special tools and workshop equipment required
- Vehicle Diagnosis Tester
- Vehicle Diagnosis System - Diagnosis Lead VAS5051B/1
- or Diagnostic Cable, 5 m without Power Supply VAS 5051/3
Measurement and testing procedures should be performed as follow to avoid the risk of an accident:
- Only the vehicle diagnostic tester VAS5051A or VAS5052 may be used to read out measured value blocks. The device must always be secured on the rear seat and operated from there by a second person.
-- Turn off the ignition and connect the vehicle diagnostic tester -1- to the diagnostic connection using the Vehicle Diagnosis System - Diagnosis Lead VAS5051B/1 or VAS5051/3 -2-.
Installed location: Left front foot well.
-- Turn on the tester -arrow-.
The tester is ready to be used when it displays a picture (photograph) of a vehicle.
Starting "Guided Fault Finding" :
-- Turn on the ignition.
-- Press the "Guided Fault Finding" button on the screen.
-- Then select the following one after the other:
- Brand
- Type
- Model year
- Version
- Engine code
-- Confirm the entered data.
Wait for the tester to check all the control modules in the vehicle.
-- Press GO TO and then select "function/component selection".
Follow the displays on the screen to start the desired functions.