Install Valve Stem Seals

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the plastic sleeve -A- that is attached to valve stem seals -B- on valve stem.

-- Lightly oil the valve stem seal.

-- Slide the valve stem seal onto the plastic sleeve.

-- Carefully press the valve stem seal onto the valve guide with the :3365  .

-- Remove plastic sleeve.

-- Insert the valve spring and valve spring plate.

-- Connect the :VAS5161A  as illustrated.

Intake Side 

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Exhaust Side 

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

If the valve retainers were removed from the assembly cartridge, they must then be inserted into the :VAS5161/18  .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Press the A:VAS5161/8A  onto the insertion device from above and capture the valve retainers.

-- Press the :VAS5161/8  down with the :VAS5161/2  and rotate the cartridge knurled thumb screw back and forth while pulling up.

-- Release the :VAS5161/2  with the knurled thumb screw pulled.

-- Remove the :VAS5161A  .

Further assembly is performed in the reverse order of removal, thereby observing the following:

-- Install the camshafts. Refer to CAMSHAFT, REMOVING AND INSTALLING .