Overview - Cylinder Head: Notes
NOTE:
Replace the cylinder head bolt.
Always replace self-locking nuts, bolts which have been tightened to tightening specifications as well as gaskets and O-rings.
The plastic protectors installed to protect the open valves must only be removed immediately before mounting the cylinder head.
The engine oil and the coolant must be changed if the cylinder head or the cylinder head gasket are being replaced.
- Alignment Pin
- Cylinder Head Gasket
- Replace after removing
- Installed position: the part number faces the cylinder head
- Cylinder Head
- Removing and installing. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
- Check for distortion. Refer to Checking Cylinder Head for Distortion
- Bolt
- 4 Nm + 90°
- Replace after removing
- Follow the procedure when loosening. Refer to Loosening Cylinder Head .
- Follow the procedure when tightening. Refer to Tightening Cylinder Head .
- Heat Shield
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Heat Shield
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Connection
- For coolant hose
- O-ring
- Replace after removing
- Coat with coolant
- Cylinder Head Bolt
- Replace after removing
- Follow the procedure when loosening. Refer to Loosening Cylinder Head .
- Follow the procedure when tightening. Refer to Tightening Cylinder Head .
- O-ring
- Replace after removing
- Coat with coolant
- Connection
- For coolant hose
- Bolt
- 9 Nm
- Mount
- For engine cover
- Engine Lifting Eye
- Bolt
- Replace after removing
- 8 Nm + 90° turn
- Partition Plate
- Ball Pin
- For engine cover
- Engine Lifting Eye
- Bolt
- Replace after removing
- 8 Nm + 90° turn
- Alignment Pin