Overview - Camshaft Housing: Notes

Fig 1: Exploded View Of Camshaft Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Cylinder Head
O-ring
- Replace after removing
- Only installed on vehicles with the engine codes CHHB, CNTA, CXCA, CXDA, CXCB and CXDB
- Coat with engine oil
Cam Adjustment Actuator
- Only installed on vehicles with the engine codes CHHB, CNTA, CXCA, CXDA, CXCB and CXDB
Bolt
- 5 Nm
- Only installed on vehicles with the engine codes CHHB, CNTA, CXCA, CXDA, CXCB and CXDB
Ball Pin
- 9 Nm
- For engine cover
O-ring
- Replace after removing
- Coat with engine oil
Plug
O-ring
- Replace after removing
- Coat with engine oil
Camshaft Position Sensor 3 -G300-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
Bolt
- Tightening specification. Refer to OVERVIEW - IGNITION SYSTEM .
Oil Separator
- Removing and installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to Tightening Specifications
Seal
- Replace after removing
Vacuum Pump
- Removing and installing. Refer to VACUUM PUMP, REMOVING AND INSTALLING .
Bolt
- Tightening specification. Refer to Vacuum Pump - Tightening Specifications .
Seal
- Replace after removing
O-ring
- Replace after removing
- Coat with engine oil
Camshaft Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
Bolt
- Tightening specification. Refer to OVERVIEW - IGNITION SYSTEM .
Bolt
- 9 Nm
Bracket
- For EVAP Canister Purge Regulator Valve 1 -N80-