LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2016 >> Golf Base, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System (Crankshaft & Cylinder Block - Service Information - CXBA, CNSA, CXBB, CNSB, CXCA, CXCB) >> 13 Crankshaft, Cylinder Block >> Piston And Connecting Rod >> Pistons, Removing And Installing >> Removing

Pistons, Removing And Installing: Removing

-- Secure the engine to the :VAS6095  . Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Mark the installed position and cylinder allocation.

-- Mark installed position and connecting rod cylinder -item 11-  OVERVIEW - PISTON AND CONNECTING ROD List Item:Connecting Rod.

-- Remove the connecting rod bearing cap and pull the piston and connecting rod upward.

NOTE:

Warm the piston to approximately 60 °C (140 °F) if it is difficult to move the piston pin.

-- Remove the locking ring from the eye of the piston bolt.

-- Remove the piston pin using the :VW222A  .

scientia non olet · About LEMON Manuals