LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2016 >> Golf Base, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System (Crankshaft & Cylinder Block - Service Information - CXBA, CNSA, CXBB, CNSB, CXCA, CXCB) >> 13 Crankshaft, Cylinder Block >> Piston And Connecting Rod >> Pistons, Removing And Installing >> Installing

Pistons, Removing And Installing: Installing

Install in reverse order of removal. Note the following: 

NOTE:

Replace the bolts were tightened with an additional turn.

Arrow on piston face points toward belt pulley side.

Offset the piston ring gap by 120°.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston with a piston ring compressor. Pay attention to the installed position -item 8-  OVERVIEW - PISTON AND CONNECTING ROD List Item:Piston.

-- Install the connecting rod bearing cap. Pay attention to the installed position -item 2-  OVERVIEW - PISTON AND CONNECTING ROD List Item:Connecting Rod Bearing Cap.

-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals