Overview - Cylinder Block, Transmission Side: Notes
- Flywheel
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- It is possible to install in one position only, the holes are offset.
- Alignment Sleeve
- Sealing Flange, Transmission Side
- Replace after removing
- With seal
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Do not oil or grease the sealing lip of seal
- Wipe off any oil on the crankshaft bearing pin with a clean cloth before installing.
- Guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft pin.
- Cylinder Block
- Bolt
- Tightening specification and sequence. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Intermediate Plate
- Illustration does not correspond to version in vehicle.
- Must be located on dowel sleeves
- Be careful not to damage or bend when installing
- Is hooked in at sealing flange. Refer to Installing Intermediate Plate
- Alignment Sleeve
- Bolt
- 60 Nm + 90° turn
- Replace after removing
- For the dual-mass flywheel
NOTE:
Only six bolts are installed, two bolt openings remain open.