Install Vibration Damper

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If necessary remove the :T10531/4  -B- and the :T10531/3  -A- from the tensioning pins.

-- Secure the vibration damper in TDC, while doing this pay attention to the tooth contour of the chain sprocket -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the :T10531/3  -A- on the tensioning pins the at the same time the hex fitting points to the vibration damper.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the :T10531/4  -B-, while doing this move the vibration damper slightly back and forth, to check in the vibration damper is correctly in the tooth contour. Tighten the collar nut, until the vibration damper can no longer be turned.

-- Place the :T10531/1  as shown on the vibration damper and tighten hand-tight using the knurled bolt -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the :T10531/4  -A- and loosen the tensioning bolt -B-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the :T10531/2  and remove with :T10531/3  .

-- Install a new vibration damper bolt with oiled O-ring -1- hand-tight.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the knurled bolt -arrows- and remove the :T10531/1  .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten vibration damper bolt using the :T10355  .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install new bolts -arrows-.

Assemble in reverse order of disassembly.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.